| The Recoflo® Water Demineralizer is able to produce
higher purity water without the need of a mixed bed polisher. In many cases, it is able to produce
water with a conductivity as low as 0.1 microseimens/cm with less than 0.010 mg/L of silica using
only the cation and anion beds.
This high level of performance is made possible by the rapid and efficient
exchange kinetics resulting from the use of fine mesh resins and low resin loading. These in combination
with the high flowrates, result in short cycle times, both in service and regeneration.
Other demineralizers are onstream for approximately 20 hours and require several hours to regenerate. The Recoflo® Demineralizer is typically onstream for less than 30 minutes and is regenerated in less than 7 minutes. The shorter cycles make the Recoflo® Demineralizer more resistant to organic fouling and allow for the more effective removal of colloidal and ionic silica.
Recoflo® Demineralizer Information
The Recoflo® TriFlo™ Demineralizer produces the very high purity water (i.e. conductivity of less than 0.1 microseimens/cm) often required to feed critical and super critical boilers. It can do this economically and simply in a single process unit from feedwaters containing up to 450 ppm of total dissolved solids. Ultrapure water can be achieved by simply adding an additional cation resin bed as a polisher after the usual two-bed demineralizer to remove the contaminating sodium ions. The TriFlo™ Demineralizer can provide solutions for applications requiring high purity water in the range of 10 - 17.5 megohm resistivity.
Recoflo® TriFlo™ Demineralizer Information
|
